HELP!! Transmission is not working properly!

[Frend]

Help! help! help !!!!!
Transmission is not working properly!

5th gear is not included. Not by hand, not in eco mode.
If, by chance, turns on 5th gear - reverse gear is not included. !!!!!

IMPORTANT !! After adapting the car goes 1 a day and everything is working. And the next day - 5th is not included.

!!!! After replacing the clutch slave cylinder machine directions 2 days is fine, then ceased to be included 5th gear.

Today, stopped at a traffic light, and could not move. Speed ​​is not enabled. The first two times drowned started and went on the third time did not work.
Car at a stop during the switch from third to second transmission of gas did not react. burning icon D.
As a result, stood minutes 5. In the "stop" would not start. only neutral. Then a miracle including speed and I drove to the house, even 5th included.
All rate includes both up and down. Home was parked and not running back. And the car was is put in the stop position!

Has been replaced by:
clutch assembly, disc, basket, guide bush, bearing
clutch slave cylinder and mount
disassembled and repaired the switching mechanism,
new accumulator,
oil in the gearbox,
new thrust switch
made all the settings,
readings are normal.
visually looked 5 different gear - all ok
computer - everything is OK, no errors.

Friends! Please help, how to fix?
I suffer 3 months and I can not fix it !!!

[Frend]

* Replacing the battery should be read as a new hydraulic accumulator!

[Nietsnut]

Have you ever thought of an electrical malfunction? There are two solenoids on the Gangsteller and they are actuated by logic (shift computer / manual operation) by means of wires, they are known to break sometimes, therefore my advise would be to measure all wiring from the shift computer (hiding under where the wipers are affixed) to the solenoids and the wiring from the engine computer sensors (speed [on the gearbox], hall [crankcase]).

But then my guess would be a solenoid cable gone bad.

[Frend]

Have you ever thought of an electrical malfunction? There are two solenoids on the Gangsteller and they are actuated by logic (shift computer / manual operation) by means of wires, they are known to break sometimes, therefore my advise would be to measure all wiring from the shift computer (hiding under where the wipers are affixed) to the solenoids and the wiring from the engine computer sensors (speed [on the gearbox], hall [crankcase]).

But then my guess would be a solenoid cable gone bad.

Thank U. I got it.
It is necessary to check the wiring from the computer to switch the gearbox and sensors!
Thank U !!!

[Nietsnut]

Remember: the shift computer is the black one located in front of the driver and the engine computer is in the middle and is alloy coloured.

[Frend]

ok!!

[Frend]

Now my main problem gearbox.
Yesterday parked is not included reverse gear.
Today moved the wires under the hood, all who saw and clutch cable. and miracle
all transmissions are gone. the car does not go!
wiggled wires and clutch cable again, and transfer included.
1st and reverse gear working car rides !!

[David]

Did you make NEW basicsettings after installing the clutch slave cilinder ?

[Frend]

Did you make NEW basicsettings after installing the clutch slave cilinder ?

yes cap. every time !

[Frend]

guys tell me what to look Owned wiring from gearbox control unit?
I will do myself, I do not know how ?! =)

[David]

An broken wire gives an error in the ecu.
No errors is mechanical malfunction.

[Frend]

with Lupo can be anything .....